COM645 Network Security Assignment Questions | Wrexham University

Assessment Task Details –Provide a Description of The Task

Configuring network devices based on the assignment brief

Hints and tips

All submitted work is expected to observe academic standards in terms of referencing, academic writing, use of language, etc. Failure to adhere to these instructions may result in your work being awarded a lower grade than it would otherwise deserve.

By submitting the coursework, you certify that, other than where collaboration has been explicitly permitted, this work is the result of your effort and that all sources for materials have been acknowledged. You also confirm that you have read and understood the codes of practice on plagiarism contained within the Wrexham Academic Regulations and that you are agreeing to be dealt with accordingly in any case of suspected unfair practice. You also certify that my attendance for the module has been at least 70%.

Marking and Moderation

Moderation.

Employability Skills Applied

On successful completion of this module, a student will have had opportunities to demonstrate achievement of the following Employability Skills:

Core Attributes

• Engaged *
• Creative *
• Enterprising
• Ethical

Key Attitudes

• Commitment *
• Curiosity
• Resilient *
• Confidence *
• Adaptability

Practical Skillsets

• Digital fluency
• Organisation *
• Leadership and teamwork
• Critical thinking *
• Emotional intelligence
• Communication

Marking criteria

Based on the assignment brief.

Assessment Objectives

• Part 1: Network Topology Build [using Packet Tracer] (10 points, 10 minutes)
• Part 2: Network Design (50 points, 35 minutes)
• Part 3: Device Configurations and Settings (50 points, 30 minutes)
• Part 4: Configure RIP version 2 Routing Protocol (30 points, 25 minutes)
• Part 5: Verify end-to-end Network Connectivity (10 points, 10 minutes)
• Part 6: Set up and Configure HTTP Services (20 points, 15 minutes)
• Part 7: Create and Apply Extended ACLS (40 points, 20 minutes)
• Part 8: Housekeeping/ Save and upload Configuration or Packet Tracer Files. (5 points, 5 minutes)

Practical test: Network Protocols and Algorithms (150 minutes)

Part 1: Network Topology Build [using Packet Tracer]

Part 2: Network Design

In this practical skills assessment (SA), you are the network administrator of a new network build. There is only 1 IP address available for this network – 192.168.33.x, where X = 0 to 255.

You are required to work out an addressing scheme that will allow this network to be configured. Make sure you conserve IP addresses. There are 12 hosts in Bangor and 12 hosts at Glyndwr.

Addressing Table

Calculate the network Masks and fill in the addressing table below:

Part 3: Device Configurations and Settings

Step 1: Configure Wrexham Router.

Configuration tasks for Wrexham-Router include the following:

Step 2: Configure Janet Router.

Configuration tasks for Janet-Router include the following:

Step 3: Configure IPv4 addresses on Glyndwr and Bangor

Part 4: Configure RIP version 2 Routing Protocol

Step 1: Configure RIP version 2 on the Wrexham Router.

Configuration tasks for the Wrexham Router include the following:

Step 2: Configure RIP version 2 on the Janet Router.

Configuration tasks for Janet Router include the following:

Part 5: Verify end-to-end connectivity [Please include screenshots].

Part 6: Set-up and Configure HTTP Services

Part 7: Insert an Extended ACL to Prevent access to HTTP from Glyndwr

Part 8: Housekeeping/ Save Configuration/ Packet Tracer Files